Built for desert homes
110° summers that push air conditioners to the limit and hard water that wears out water heaters and fixtures — we know your climate.
Furnace Repair in Cedar City
Here, the furnace is the hardest-working appliance in the house
Furnace repair in Cedar City is a different job than it is in St. George. The heating season starts earlier, ends later and asks far more of the equipment in between. January lows sit in the teens, cold snaps dip well below that, and a furnace may cycle dozens of times a night for weeks. Parts that would last years in a mild climate wear out faster here: igniters crack, flame sensors foul, blower bearings dry out and heat exchangers see far more thermal cycling.
Element repairs gas furnaces across Cedar City and Iron County 24/7, and every call includes a check of the burners, venting, gas connections and carbon monoxide levels. When a furnace is too old or too damaged to repair sensibly, we price a replacement next to the repair so you can choose. Our St. George heating repair team handles the same work down the hill, and Cedar City is a regular part of their route. For the full lineup, see HVAC services in Cedar City, or the Cedar City page for everything we do here.
- Cold-Night Calls Answered No heat at 2 a.m. in a snowstorm gets a real person on the phone.
- CO and Venting Checked Every repair ends with a carbon monoxide and flue test.
- Upfront Price You approve a written price before the repair begins.
Symptom Check
What a Cedar City furnace does before it quits
Swap the filter and check the thermostat first. If any of these keep happening, call us.
-
Blower Runs, Air Is Cold
The fan pushes air but the burners never catch, or shut off within a minute.
-
Clicks with No Ignition
A hot-surface igniter that has cracked, or a gas valve that isn’t opening.
-
Cycles Every Few Minutes
Short cycling in deep cold often means a dirty flame sensor or an overheating limit switch.
-
Boom at Startup
A thump when the burners light is delayed ignition. Have it looked at soon.
-
Gas Bill Out of Line
A heating bill far above last winter’s, with similar weather, points to a furnace losing efficiency.
-
CO Alarm or Gas Smell
Get everyone outside first, then call us and the gas utility from outdoors.
What We Do
Furnace repair in Cedar City, plus installation and replacement
From a single failed igniter to furnace installation in Cedar City homes, sized for Iron County winters.
- Igniters & Flame Sensors The two parts most likely to fail after months of nightly cycling, replaced and tested.
- Blowers & Inducer Motors Motors, capacitors and bearings that leave heat stuck in the cabinet.
- Gas Valves & Burners Valves, manifold pressure and burners set for a clean, steady flame.
- Furnace Cleaning & Tune-Ups Burners, flame sensor, blower wheel and filter cleaned each fall, including the $59 furnace tune-up.
- Furnace Installation New high-efficiency gas furnaces sized by heat-load calculation, not a guess from the old nameplate.
- Heat Exchangers & CO Safety Cracked exchangers found, flue draft confirmed and carbon monoxide measured after every job.
How It Works
From a cold house to steady heat
Most common furnace repairs are finished on the first visit with parts we carry.
-
Call Any Hour
Describe what the furnace is doing. If you smell gas, call from outside the house.
-
Trace the Fault
We test ignition, flame sensing, gas pressure, airflow, limits and the control board.
-
Pick Repair or Replace
You see the repair price and, if the furnace is near the end, a replacement price beside it.
-
Fix, Test, Verify
We make the repair, check venting and CO, and confirm the temperature rise across the furnace.
Southern Utah crews. Desert‑tough service.
Why Southern Utah homeowners choose Element
Two offices, one local team
Real offices in St. George and Hurricane, with crews serving Washington, Santa Clara, Ivins, Cedar City and Springdale — not a call center.
Award-winning work
Voted Best of Southern Utah Gold in 2025 and 2026, and Best of Iron County 2025.
Here 24/7
Burst pipe at 2 a.m. or no AC on a 110° Sunday — a real technician answers the call.
No heat and snow in the forecast?
Our Cedar City heating team answers 24/7. Mention $50 off any HVAC service when you call.
Maintenance Membership
Ready for 110° desert summers.
Seasonal checkups for every system in your home.
Seasonal checkups catch small problems before they become emergencies — and keep your systems running efficiently all year.
- Annual whole-home plumbing inspection
- Water heater flush & safety check
- Seasonal heating & AC tune-ups
- Priority scheduling for members
- Member savings on repairs
Furnace questions from Cedar City homeowners
Why does my furnace short cycle only when it’s very cold?
In deep cold the furnace runs longer and hotter, so a marginal part finally shows itself. A restricted filter or a dirty blower wheel lets the heat exchanger overheat and trip the high-limit switch, which shuts the burners off early. A fouled flame sensor does the same thing from the other direction. Both are routine repairs, and both are caught on a fall tune-up.
How much does furnace repair cost in Cedar City, Utah?
The price depends on which part failed, how accessible the furnace is, whether a safety issue like a cracked heat exchanger turns up and the age of the system. An igniter or flame sensor is at the simple end; a blower motor or control board costs more. Your technician diagnoses first, then gives you a written, upfront price to approve before any work starts, with a replacement option if that makes more sense.
How do I know when furnace replacement in Cedar City makes sense?
When the furnace is old, the repair is a major part, or you’ve paid for several repairs in the last few winters, replacement usually costs less over time. A cracked heat exchanger is almost always a replacement. We’ll show you both prices, explain what we found and leave the decision to you. See heating installation for how a new system goes in, and financing if you’d rather spread the cost.
Does furnace cleaning in Cedar City really matter if the furnace is working?
Yes, more than in a mild climate. A furnace that runs for months builds up dust on the flame sensor, burners and blower wheel, and that buildup is what causes most mid-winter failures. A fall cleaning and tune-up also catches a cracked igniter or a weak inducer before the first cold snap. The $59 furnace tune-up covers one system.
What should I do while I wait for the technician?
Keep interior doors open so heat spreads evenly, run a space heater in the room you’re using, and open cabinet doors under sinks on exterior walls so pipes stay warmer. If the house gets very cold, let faucets drip to keep lines from freezing. If a pipe does freeze or split, our Cedar City plumbers handle that too.
*Offers cannot be combined with other promotions or applied to dispatch fees. No cash value. Must present offer at time of service. Call for details.