Built for desert homes
110° summers that push air conditioners to the limit and hard water that wears out water heaters and fixtures — we know your climate.
Repiping in St. George
One project instead of a leak every season
Some St. George houses reach a point where patching stops making sense. Older homes may still have galvanized steel that rusts from the inside, or gray polybutylene that’s known for sudden failures. Newer homes aren’t immune either: years of very hard water can pit copper and choke lines with scale until pressure drops and pinhole leaks start appearing in different rooms.
Repiping replaces the supply pipe throughout the house, or just the worst runs, with new line sized for your fixtures. Most homes here are a good fit for PEX, which shrugs off scale and needs fewer fittings, and we install copper when you prefer it. Our plumbers plan access to keep drywall openings small, coordinate permits and inspections, and pressure-test before closing up. Ask about financing, and about pairing new pipe with a water softener to protect it.
- PEX or Copper We explain the trade-offs and you choose.
- Permits Handled We pull permits and schedule the inspections.
- Financing Available Spread a whole-house project over time.
Symptom Check
Reasons it may be time to repipe
One leak is a repair. A pattern of these points to the pipe itself.
-
Leaks in Different Rooms
Pinholes popping up in one spot after another over a year or two.
-
Rusty Water
Brown or orange water from galvanized pipe corroding inside.
-
Pressure Keeps Dropping
Scale narrowing the pipe until two fixtures can’t run at once.
-
Polybutylene Pipe
Gray plastic supply lines with a known history of failing.
-
Visible Corrosion
Green crust on copper or flaking rust on exposed fittings.
-
Remodel on the Way
Walls are open anyway, the best time to replace tired pipe.
What We Replace
Repiping sized to your home
From a single failing run to every supply line in the house.
- Whole-House Repipes Every hot and cold supply line replaced and tested.
- Partial Repipes Just the worst runs, when the rest of the system is sound.
- Manifold Systems A home-run layout with a dedicated line to each fixture.
- Slab Line Reroutes Leaking under-slab pipe abandoned and rerouted overhead.
- Main Service Line New pipe from the meter, done at the same time if needed.
- Access & Patching Small, planned openings in drywall, patched when we’re done.
How It Works
What a repipe looks like
A planned project with a clear scope, not an open-ended job.
-
Inspect the System
We identify pipe types, condition and where leaks have been.
-
Scope and Price
You get material options, a plan and a firm price to approve.
-
Replace the Pipe
New lines in, old ones out, with water off only in short windows.
-
Test and Inspect
Pressure test, city inspection, then walls patched.
Southern Utah crews. Desert‑tough service.
Why Southern Utah homeowners choose Element
Two offices, one local team
Real offices in St. George and Hurricane, with crews serving Washington, Santa Clara, Ivins, Cedar City and Springdale — not a call center.
Award-winning work
Voted Best of Southern Utah Gold in 2025 and 2026, and Best of Iron County 2025.
Here 24/7
Burst pipe at 2 a.m. or no AC on a 110° Sunday — a real technician answers the call.
Tired of leak after leak?
Get a repiping estimate from our St. George plumbers. Financing is available.
Maintenance Membership
Ready for 110° desert summers.
Seasonal checkups for every system in your home.
Seasonal checkups catch small problems before they become emergencies — and keep your systems running efficiently all year.
- Annual whole-home plumbing inspection
- Water heater flush & safety check
- Seasonal heating & AC tune-ups
- Priority scheduling for members
- Member savings on repairs
Repiping questions from St. George homeowners
How long does a whole-house repipe take?
Most homes take a few days, depending on size, number of bathrooms and how easy the walls and attic are to reach. Water is usually off only for short stretches while we tie in new lines, so you can stay in the house. Your estimate includes the expected schedule, including the city inspection.
Is PEX or copper better in St. George?
For most homes here we recommend PEX. It resists the scale that builds in copper with our hard water, flexes with the house and uses fewer joints, which means fewer places to leak. Copper is durable and some homeowners prefer it. We price both so you can compare.
Will you have to tear out a lot of drywall?
No. We plan routes through the attic, closets and interior walls so openings are small and few. Many runs can be fished through without opening a wall at all. When we do cut drywall, we make clean openings at planned spots and patch them after the inspection passes.
Can I repipe just part of the house?
Yes, if the rest of the system is in good shape. A common example is replacing a leaking hot line under the slab by rerouting it overhead, rather than repiping everything. We’ll show you what we find and price both options. Start with a plumbing inspection if you’re not sure.
How do I keep new pipe from scaling up?
Treat the water. A properly sized water softener keeps calcium and magnesium out of your new lines, fixtures and water heater. Many St. George homeowners add one at the same time as the repipe, when the main is already open and the plumbing is easy to reach.
*Offers cannot be combined with other promotions or applied to dispatch fees. No cash value. Must present offer at time of service. Call for details.