Built for San Juan winters
Boilers and radiant heat that run all winter, high-altitude water heaters at 6,512 ft, and frozen lines — we know your climate.
Radiant Heat in Durango
Heat that moves through water, not air
A hydronic system pumps hot water from a boiler through tubing in your floors, fin-tube baseboards or radiators. There are no vents blowing dust and no rush of warm air that fades the minute it shuts off. The floor holds the heat, the room stays steady, and in a long Southwest Colorado winter, that comfort is hard to give up once you’ve had it.
When a zone won’t warm up, the cause is usually in the distribution: air trapped in a loop, a sticking zone valve, a tired circulator or a manifold that was never balanced. Our team traces the problem through the whole system. We also design new radiant zones for additions and remodels, and size them against what your boiler can actually deliver. If you’re starting from scratch, a combi boiler can run the floors and your hot water.
- Whole-System Thinking Boiler, pumps, valves and loops checked together.
- Designed to Fit New zones sized to the room and the heat source.
- Upfront Pricing The price is set and approved before tubing goes in.
Symptom Check
Signs a radiant loop needs attention
Hydronic problems tend to show up room by room before they take down the whole house.
-
Cold Spots in the Floor
Patches that stay cool often mean air in the tubing or poor flow through that loop.
-
A Zone That Never Catches Up
One area lags all day while the rest of the house is comfortable.
-
Gurgling in the Pipes
Trapped air moving through baseboards or radiators needs to be purged.
-
Pressure Drops Overnight
A slow leak in a loop, fitting or relief valve lets the system drain down.
-
Zone Valve Stuck
A room that overheats or won’t heat at all can trace back to one valve.
-
Snowmelt Not Clearing
Ice on a heated drive or walkway means the loop or its controls need a look.
What We Handle
Every part of the hot-water loop
From a single cold bathroom floor to a whole-house system design.
- Radiant Floor Heat New in-floor zones designed and installed, and existing ones repaired.
- Baseboard & Radiators Fin-tube and cast-iron emitters bled, balanced, repaired or added.
- Manifolds & Zoning Zone valves, manifolds and thermostats set so every room gets its share.
- Circulator Pumps Noisy or failed pumps replaced and flow rates checked.
- Snowmelt Systems Heated driveways, walks and steps so you shovel less all winter.
- The Boiler Behind It Repairs, tune-ups and replacements for the heat source itself.
How It Works
How we fix or build a radiant system
Repairs and new zones both begin with understanding the loop you have.
-
Book a Visit
Tell us which rooms are cold, or what you’d like to add.
-
Map the Zones
We trace each loop, check temperatures, flow and pressure, and find the weak point.
-
Plan and Price
You see the repair or design, the cost and the timeline, then approve.
-
Purge and Balance
Air is cleared, flow is balanced and every zone is tested warm.
Durango crews. Mountain‑tough service.
Why Durango homeowners choose Element
Local to Southwest Colorado
A real office on Turner Drive and crews serving Durango, Bayfield, Ignacio, Hesperus and Pagosa Springs — not a call center.
Licensed in Colorado
Colorado Plumbing Contractor PC.0004697 and Master Plumber MP.03001859, with every job backed by our full service guarantee.
Here 24/7
Burst pipe at 2 a.m. or a cold boiler on a Sunday — a real technician answers the call.
Cold floors or a zone that won’t heat?
Our Durango team traces hydronic problems any day of the week, and you approve the price before we start.
Maintenance Membership
Ready for San Juan winters.
Seasonal checkups for every system in your home.
Seasonal checkups catch small problems before they become emergencies — and keep your systems running efficiently all year.
- Annual whole-home plumbing inspection
- Water heater flush & safety check
- Seasonal boiler tune-ups
- Priority scheduling for members
- Member savings on repairs
Radiant heat questions from Durango homeowners
Why is one room colder than the rest of the house?
In a hydronic home, the usual suspects are air trapped in that loop, a zone valve that isn’t opening fully, or a manifold that was never balanced. Less often, the boiler can’t keep up with the total load. We check temperatures on each loop to pinpoint which one it is.
Can you add radiant heat to an existing house?
Often. Remodels, new bathrooms, basements and additions are the easiest places, since the floor is already open. We confirm your current boiler has the capacity, or plan a new heat source if it doesn’t. A combi boiler is one option when space is tight.
Do radiant systems need maintenance?
The tubing itself needs very little, but the parts that move it do. Pumps, zone valves, the expansion tank and the boiler all benefit from a yearly check, and the system fluid should be tested. Pairing that with your boiler service keeps the whole loop healthy.
Is a snowmelt system worth it in Durango?
For a steep driveway, a north-facing walk or front steps that ice over, it often makes sense. A snowmelt loop runs warm fluid under the surface so snow and ice don’t build up. We’ll talk through the area, the heat source and the controls before you commit.
Do you service radiant heat in Pagosa Springs?
Yes. We work on hydronic systems throughout La Plata and Archuleta counties, including Pagosa Springs, Bayfield and Ignacio. Older ranch homes and newer mountain builds both use radiant heat out there, and the troubleshooting is the same. Call any time to set up a visit.
*Offers cannot be combined with other promotions or applied to dispatch fees. No cash value. Must present offer at time of service. Call for details.